E-TECH G106 Digital Head Lock AVCS Tail Gyro for Heli

*Brand Name:E-TECH

*Model Name:G106

*Color:Black

*Material:ABS

*Compatible device:Align TREX 200 250 450 500 550 600 700

*Operating voltage:4v-6v

*Operating temperature:-10°C~+45°C

*Dimensions(mm):30(L)x18(W)x8.3(H)

*Packing Size(mm):89(L)x55(W)x24(H)

*Weight(g):13/35

User Guide:

- The G106 Gyro is designed for 6ch and up R/C system only. 

sensitivity of the gyro can be make viathe transmitter Rudder ATV and/or thronght the switches on the gyro unit

- Connect the gyro to the rudder channel of the receiver and the gain control , wire should be conn-nected to AUX channel (Signal) of The receiver. Connect the rudder servo to gyro . Turn on the powe of ther transmitter then the receiver .place the AUX switch on the transmiter in the down position (ratehold , the LED on the gyro is turn Green)

- Make sure the servo arm at the center position Adjust the length of the rudder control rod to meet the full traveling range of the rudder of the rudder.In initial flying , the adjustment should be done unde rate holding mode . When the initial setting is completed and Check the correct rudder movement during low altitude.

- If the rudder control drift one way. put your helicopter down on the ground and adjust the length of the rudder control rod . After finishing the adjustment , turn the gyro to head holding mode (place AUX suitch on the transmitter in the up position) , the sensitivity of the gyro should be between 70%-80% .