DH25 CREE XM-L U2 LED 1000 Lumens 3-Mode Canister Diving Light

◆Model: DH25

◆Bulb: CREE XM-L U2 LED (Max 1000 Lumens)

◆Color temperature: 6500k.

◆Three output levels. High> Low>Strobe

◆Runtime: High: 210 min, Low: 360 min, Strobe: 300 min

◆Light head: 80° vertical adjustable

◆Reflector: Glossy Aluminum reflector

◆Lens: 6mm Polycarbonate Board.

◆Body material: Durable aircraft-grade aluminum.

◆Angle of light beam 10° hot spot, 110° periphery

◆Surface treatment: Premium Type III hard-anodizing.

◆Color: Black

◆Battery: 26650 Li- ion battery *2 in canister(not included)

◆With battery over-discharging protection, polarity reversing protection

◆Operation voltage: 6V to 10V.

◆Waterproof: 100 meters underwater

◆Dimensions: light head: 70mm (length) *46mm (dia. of head); canister: 166(length)*36mm (dia. of body)

◆Weight(g): 600/1320

◆Impact resistance: 1.5M.

BATTERY INSTALLATION

1. Remove the top cover of the canister by turning counter-clockwise.

2. Remove used batteries and replace with fresh batteries as shown by the polarity stickers.

3. Mount the cover by turning clockwise. 

BATTERY CHARGING

1. Plug the charger in the wall power socket, the indicator light is green in the free-load status.

2. Put the battery in the slot of the charger.

3. The indicator light is red if the battery is not fully charged; it will turn green after fully charged.

4. Take out the fully charged battery and use them in the canister.

ON/OFF

Push the switch forward to activate the light.

The switch will go back to original position automatically.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.